Engine piston temperature is too high, easy to overheat and happen embrace burn melting cylinder; Rubber seal, triangle tape, tires and other overheating, easy ageing, shorten service life, slow performance,; The starter, generators, regulators electrical equipment of the coil overheat, extremely easy burned and scrap.

 

Avoid dirty

The fuel filter, oil filter, air cleaner, hydraulic oil filter and all kinds of mesh parts if dirty, will lead to filtration effect becomes poor. Water tank, air cooled heat sink the engine block and cylinder head heat sink, cooler heat sink the component such as dirty, can lead to heat is bad, the temperature is too high.

 

Avoid the

In the engine cylinder cushion when installation the cannot be installed, otherwise, it will lead to premature cylinder gasket ablation damage; Engine fan blades installation shall not make the; The direction of decorative pattern of tires, people fonts decorative pattern tires, installation of the ground after mark should make people pointed to the word.

 

Avoid short of

Engine air lock piece, should be installed in pairs, such as leaks installs or missing: will lead to valve control and crashed the piston and a; Engine connecting rod bolt, flywheel bolt, the drive shaft, bolt install on split cotters, lock screw, insurance piece or spring cushion against pine device, once leaks installs, in use will probably lead to serious faults; The engine room to lubricating timing gears gear oil nozzle once leaks installs, it will lead to serious leaking oil.

 

 

 

 

Reproduced, please indicate   http://www.parts-processing.com/