Everyone knows machinery fittings processing is very tired, hard work, and how to find a good trick! Save time, energy and operation! Then tell you in machining process to save time, energy! Send some process of small door, hope everybody progresses together to reply your post

mechanical fittings processing  doohickey one:

When the hex wrench, cannot handle short on 1 May, when will slightly larger than the diameter of pipe wrench from a section milling
Apply wrench into groove, can be used as a long handle.

machinery accessories  processing  doohickey two:

What is said about tightening workpiece position again: first, but the clamping? I think, first for a piece of clamping positioning, because the clamping definitely try distortion, so, should first clamping positioning, for six point positioning, seek to limit its freedom.

mechanical accessories  processing  doohickey three:

When driving pulley and often pulley between axles skid
In the ￠with 15 ~ axle 18mm delimit nest nest draw drill series
This can be formed to prevent slippery adsorption
The boss will reward waste

mechanical fittings processing  doohickey four:

Will take away the jaw vice pliers mouth, the other two, the M4 threaded holes with two thick 1.5 mm rope-grip to flush the plate, aluminum rivet with his two thick 0.8 mm rivet on its hard yellow copper with M4 in March to clamp screw fastening one mouth, durable soft clamp. This can also be bad, protect parts are interchangeable

machinery fittings processing  doohickey five:

From small parts with magnet (cost) and are not easy absorption
But in one of the magnets below suck a sizzling 2
Not only can absorb many small
And immediately pull small iron will be spilled into the collection box
By heart but not very practical